THE FRIDGE GUARDThe Fridge Guard is an under-voltage protection device rated at 5 Amps. The Fridge Guard will disconnect if the mains go below the lower limit and re-connect automatically after the supply returning and remaining above the lower limit for the duration of the wait time.PLEASE READ CAREFULLY1. Make sure that your load does not exceed the rating of the Fridge Guard which is 5 AMPS. If this is exceeded, the Fridge Guard may be damaged, and the warranty will be void.2. Plug the Fridge Guard into the mains and plug your appliance into the Fridge Guard.3. Do not connect more than one appliance to the Fridge Guard.4. On first switching on, the yellow LED will indicate and there will be no output while the Fridge Guard monitors the mains. If the mains level is acceptable, the Yellow LED is lit indicating that the Fridge Guard is in wait mode. At the end of the wait time and if the supply is above the lower limit the green LED goes on and the load is connected.5. It is recommended that the Fridge Guard is kept switched on, and the appliance switched on and off as required, to prevent activating the time delay every time the appliance is switched on.6. If the red LED shows, the voltage is too low. When the voltage is acceptable, the Fridge Guard will go to yellow.SPECIFICATIONS• Nominal Voltage 230V (or 110V)• Current Rating 5Amps• Frequency 50/60Hz• Mains Spike Response Time less than 10ns• Mains Spike Discharge Amps 6.5kA • Spike Protection 160J• Wait Time 90 seconds• Ideal For Fridges, freezers and coolers• Socket availability UK13, Schuko, 5A Indian • Weight 250gm• Dims 180x90x95mm